Parti

Nessuna parte richiesta.

Unscrew these #1 Philips screws, and leave them in the plastic foot holders.
  • Unscrew these #1 Philips screws, and leave them in the plastic foot holders.

Aggiungi Commento

Remove the foot holders and place them on the side
  • Remove the foot holders and place them on the side

Aggiungi Commento

Remove the four feet and place them on the side
  • Remove the four feet and place them on the side

Aggiungi Commento

Remove these #1 Philips screws, and leave them in their counterbores
  • Remove these #1 Philips screws, and leave them in their counterbores

Aggiungi Commento

Lift grey shell off and place to the side to reveal:
  • Lift grey shell off and place to the side to reveal:

  • ADC and Logic board

  • Bluetooth module

  • Strain gauges

  • Battery holder

Aggiungi Commento

The ADC and Logic board contains:
  • The ADC and Logic board contains:

  • Bluetooth module

  • Power button connector

  • Battery and sync button connector

  • Strain gauge wheatstone bridge connections

    • The topmost connection for each of the four bridge connections is the ground; relative to this, the two middle connections should be at 1.2 VDC, and the bottom should be at 2.7 VDC

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 10 persone hanno completato questa guida.

Pete Marchetto

Membro da: 25/01/2011

421 Reputazione

1 Guida realizzata

Great stuff Pete, being able to fix the wifi board got me mucho street cred with " her indoors " and lots of other goodies that go along with that

HENRY - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 19

Ultimi 30 Giorni: 65

Tutti i Tempi: 7,553