Strumenti

Nessun attrezzo richiesto.

Parti

Nessuna parte richiesta.

Use a large plastic opening tool along the rear panel: There are 4 clips to release. There are 4 clips to release.
  • Use a large plastic opening tool along the rear panel:

    • There are 4 clips to release.

Aggiungi Commento

Slide the cover along the plastic frame. Slide the cover along the plastic frame.
  • Slide the cover along the plastic frame.

Aggiungi Commento

Slide off the largest plastic pieces.
  • Slide off the largest plastic pieces.

Aggiungi Commento

Bend the second small plastic piece to release it from the rubber piece. Now you can slide it out. Now you can slide it out.
  • Bend the second small plastic piece to release it from the rubber piece.

  • Now you can slide it out.

Aggiungi Commento

Slide out the hard drive as shown in the picture Make sure to slide as shown or you may damage the USB bridge logic board.
  • Slide out the hard drive as shown in the picture

  • Make sure to slide as shown or you may damage the USB bridge logic board.

Aggiungi Commento

Remove the 4 rubber piece from the plastic frame at each corner. Remove the 4 rubber piece from the plastic frame at each corner.
  • Remove the 4 rubber piece from the plastic frame at each corner.

Aggiungi Commento

Remove the rubber piece from the  SATA/USB bridge logic board.
  • Remove the rubber piece from the SATA/USB bridge logic board.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Gaetan

Membro da: 26/12/2012

9.237 Reputazione

27 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 5

Tutti i Tempi: 910