Introduzione

The speaker is attached to the circuit board with two wires and is glued onto the front case. After the speaker is removed the new speaker will need to be re-glued and re-soldered into place.

First, apply pressure with your thumb on the top of the battery cover.
  • First, apply pressure with your thumb on the top of the battery cover.

Aggiungi Commento

Next, pull down on the cover until it begins to slide.
  • Next, pull down on the cover until it begins to slide.

Aggiungi Commento

Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).
  • Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).

Aggiungi Commento

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.
  • Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.

Aggiungi Commento

Detach back part of the case by gently lifting up.
  • Detach back part of the case by gently lifting up.

Aggiungi Commento

Remove the circuit board from the front part of the radio case.
  • Remove the circuit board from the front part of the radio case.

  • Clip the red and black connecting wires at the base closest to the circuit bored in the spots denoted by the two red circles.

Aggiungi Commento

Scrape off the glue on the outer lining of the speaker using the metal spudger.
  • Scrape off the glue on the outer lining of the speaker using the metal spudger.

Aggiungi Commento

Pry the speaker from the case using the metal spudger.
  • Pry the speaker from the case using the metal spudger.

  • This should not take excessive force, so make sure all remaining glue is scraped off from the edges if it will not easily come out.

Aggiungi Commento

The speaker is now disassembled!
  • The speaker is now disassembled!

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Team

Cal Poly, Team 19-43, Regan Winter 2013 Membro di Cal Poly, Team 19-43, Regan Winter 2013

CPSU-REGAN-W13S19G43

3 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 397