Introduzione

In order to replace the RAM, hard drive, or wireless card in the laptop you must first remove the back panel, as shown in this guide.

Parti

Nessuna parte richiesta.

Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.
  • Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.

  • Flip your device over so the bottom panel is facing up.

Aggiungi Commento

Slide the lock switch below the bottom right of the battery to the left.
  • Slide the lock switch below the bottom right of the battery to the left.

  • The battery is held in by a latch in the front and tabs in the back.

  • Lift up the battery, rotating it up and away from you, then pull it out.

  • To put the battery back in, line it up with the battery bay and the holes for the tabs. Then let the battery rotate towards you and press down until the latch engages and you hear a click.

Aggiungi Commento

Unscrew one Phillips #1 screw from the back panel.
  • Unscrew one Phillips #1 screw from the back panel.

  • The screw is on a spring and attached to the panel. It will pop up, but will not separate from the back panel.

Aggiungi Commento

Slide the back panel down and pull it up. Slide the back panel down and pull it up.
  • Slide the back panel down and pull it up.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 5 persone hanno completato questa guida.

John Sutton

Membro da: 24/04/2014

1.349 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 11-51, Amido Spring 2014 Membro di Cal Poly, Team 11-51, Amido Spring 2014

CPSU-AMIDO-S14S11G51

4 Membri

12 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 21

Tutti i Tempi: 1,900