Parti

Nessuna parte richiesta.

Place the all in one computer face down on a soft, clean surface to avoid scratching the front. Press the tab on the stand cover and lift up. Press the tab on the stand cover and lift up.
  • Place the all in one computer face down on a soft, clean surface to avoid scratching the front.

  • Press the tab on the stand cover and lift up.

Aggiungi Commento

Remove the four phillips screws that attach the stand to the computer. Tilt the stand up and out. Tilt the stand up and out.
  • Remove the four phillips screws that attach the stand to the computer.

  • Tilt the stand up and out.

Aggiungi Commento

Starting from the optical drive, pry the back cover up with a plastic spudger. The cover is held in place by fragile plastic clips.  Careful to not break them. The cover is held in place by fragile plastic clips.  Careful to not break them.
  • Starting from the optical drive, pry the back cover up with a plastic spudger.

  • The cover is held in place by fragile plastic clips. Careful to not break them.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 19 persone hanno completato questa guida.

Tyler

Membro da: 19/06/2012

3.997 Reputazione

18 Guide realizzate

Team

TechForce Membro di TechForce

Business

2 Membri

18 Guide realizzate

I took the back cover off because everytime i connected the power cable the blue light on the power cable would go out and in taking off the back cover i might find something obvious. I did not find anything obvious except for a plastic clip floating around by itself. this may be the cause to a short i am thinking. Any ideas?

kim - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 14

Ultimi 7 Giorni: 87

Ultimi 30 Giorni: 368

Tutti i Tempi: 19,011