Introduzione

Use this guide to replace a damaged front cover or to access the inner parts of the camera.

Parti

Nessuna parte richiesta.

Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
  • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

Aggiungi Commento

On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
  • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

  • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

Aggiungi Commento

Remove three medium length screws from the bottom of the camera
  • Remove three medium length screws from the bottom of the camera

Aggiungi Commento

Remove the two medium length screws on the front panel of the camera above the lens mount.
  • Remove the two medium length screws on the front panel of the camera above the lens mount.

  • Once you done, you may use the Spudger to panel from non-grip side.

  • If you start on the grip side, it will be more challenging to loosen the panel.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Daniel Bussone

Membro da: 28/01/2011

1.206 Reputazione

11 Guide realizzate

Team

Cal Poly, Team 3-41, Regan Winter 2011 Membro di Cal Poly, Team 3-41, Regan Winter 2011

CPSU-REGAN-W11S3G41

2 Membri

11 Guide realizzate

This should be labelled: Easy.

tjt263 - Replica

Okay, there are several steps missing.

tjt263 - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 5

Ultimi 7 Giorni: 17

Ultimi 30 Giorni: 34

Tutti i Tempi: 4,129