Introduzione

This is the beginning process to remove or replace any functional component in the AirPort.

Parti

Nessuna parte richiesta.

Remove the three 5mm T7 Torx screws from the back panel.
  • Remove the three 5mm T7 Torx screws from the back panel.

Aggiungi Commento

Remove one 5mm phillips screw located under the identification sticker.  You will need to remove the sticker or make a hole to get to the screw.
  • Remove one 5mm phillips screw located under the identification sticker. You will need to remove the sticker or make a hole to get to the screw.

Aggiungi Commento

Separate the bottom and top casings.
  • Separate the bottom and top casings.

Aggiungi Commento

Remove the metal case from the top case of the AirPort, there are no screws holding it on. Remove the four screws from the metal casing.
  • Remove the metal case from the top case of the AirPort, there are no screws holding it on.

  • Remove the four screws from the metal casing.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Michael Garcia

Membro da: 12/10/2011

369 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 17-15, Regan Fall 2011 Membro di Cal Poly, Team 17-15, Regan Fall 2011

CPSU-REGAN-F11S17G15

3 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 13

Tutti i Tempi: 1,640