Introduzione

In this guide, you will be able to remove the motherboard from a creative ZiiO and use a soldering iron while doing so.

Remove the back panel by using the plastic opening tool to carefully pry around the panel's edges. The volume control button and the top power button may fall out during this step. The volume control button and the top power button may fall out during this step.
  • Remove the back panel by using the plastic opening tool to carefully pry around the panel's edges.

    • The volume control button and the top power button may fall out during this step.

Aggiungi Commento

Remove the copper plate covering the motherboard by desoldering the ten solder points. The solder point in the bottom right corner is marked but hidden by the soldering iron. The solder point in the bottom right corner is marked but hidden by the soldering iron.
  • Remove the copper plate covering the motherboard by desoldering the ten solder points.

  • The solder point in the bottom right corner is marked but hidden by the soldering iron.

Aggiungi Commento

Remove the adhesive tape covering the three wires connected to the motherboard. Desolder the solder points connecting the wires to the motherboard.
  • Remove the adhesive tape covering the three wires connected to the motherboard.

  • Desolder the solder points connecting the wires to the motherboard.

Aggiungi Commento

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Disconnect the ribbon cable that is attached underneath the copper plate. Disconnect the other ribbon cable that is connected next the copper plate in the corner of the circuit board. Disconnect the other ribbon cable that is connected next the copper plate in the corner of the circuit board.
  • Disconnect the ribbon cable that is attached underneath the copper plate.

  • Disconnect the other ribbon cable that is connected next the copper plate in the corner of the circuit board.

Aggiungi Commento

Remove the four 4mm Philips #00 screws  holding the motherboard to the casing. The copper plate will be removed by now. However, the picture does not show this.
  • Remove the four 4mm Philips #00 screws holding the motherboard to the casing.

  • The copper plate will be removed by now. However, the picture does not show this.

Aggiungi Commento

Lift up the motherboard. A mesh-looking strip on the left side will be connected to the bottom of the motherboard.
  • Lift up the motherboard.

  • A mesh-looking strip on the left side will be connected to the bottom of the motherboard.

  • Remove the tape on top of the strip and use tweezers or pliers to pull on the strip to unplug it.

Aggiungi Commento

Remove the red and black wires with a soldering iron that are located underneath the motherboard.
  • Remove the red and black wires with a soldering iron that are located underneath the motherboard.

  • Do not cut or damage the wires in the process. They will be needed for the new motherboard.

Aggiungi Commento

Remove the old motherboard and dispose of it resposibly.
  • Remove the old motherboard and dispose of it resposibly.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Benedict Samoy

Membro da: 16/04/2013

19 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 14-10, Maness Spring 2013 Membro di Cal Poly, Team 14-10, Maness Spring 2013

CPSU-MANESS-S13S14G10

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,030