Introduzione

The table guard is essential in making sure the Craftsman Model 315.10721 makes the desired cuts. Keep in mind when performing the replacement that disassembling the table guard is time consuming.

Parti

Nessuna parte richiesta.

Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.
  • Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.

Aggiungi Commento

Pivot the table guard from its upright position to an angle.
  • Pivot the table guard from its upright position to an angle.

  • Using a Phillips #1 screwdriver, remove the 1" Phillips screw and the nut on the opposite side.

Aggiungi Commento

Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.
  • Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.

  • Carefully remove the main case to expose the inside of the saw.

Aggiungi Commento

Remove the old table guard by gently lifting it away from the main case.
  • Remove the old table guard by gently lifting it away from the main case.

  • Replace the old table guard with the new one by placing it in the same orientation as the one removed.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Riley Hilliker

Membro da: 14/10/2014

546 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 4-47, Amido Fall 2014 Membro di Cal Poly, Team 4-47, Amido Fall 2014

CPSU-AMIDO-F14S4G47

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 252