Introduzione

If the screen is cracked or not working it may be necessary to replace it. This guide will show how to conduct a screen replacement.

Place the meter face down, so the back panel and screws can be seen.
  • Place the meter face down, so the back panel and screws can be seen.

Aggiungi Commento

Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver. Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.
  • Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.

Aggiungi Commento

Remove the back panel of the device by lifting upward.
  • Remove the back panel of the device by lifting upward.

  • Remove the battery from the meter before continuing.

Aggiungi Commento

Remove the four 7mm Phillips screws holding the circuit board in place. Remove the four 7mm Phillips screws holding the circuit board in place.
  • Remove the four 7mm Phillips screws holding the circuit board in place.

Aggiungi Commento

Gently lift the circuit board away from the device casing.
  • Gently lift the circuit board away from the device casing.

  • Remove the battery after removing the back cover to reduce the chances of short-circuiting the circuit board.

Aggiungi Commento

The screen is located at the top of the device.
  • The screen is located at the top of the device.

Aggiungi Commento

Carefully remove screen from device by lifting upward.
  • Carefully remove screen from device by lifting upward.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Anna Kihm

Membro da: 13/10/2014

793 Reputazione

5 Guide realizzate

Team

Clemson, Team 2-4, Benson Fall 2014 Membro di Clemson, Team 2-4, Benson Fall 2014

CLEM-BENSON-F14S2G4

4 Membri

6 Guide realizzate

my multimeter display is broken, where can i buy a new one?

allwynrajkumar - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 15

Tutti i Tempi: 1,127