Introduzione

This guide should be used if our guide, "Cleaning Function Buttons", doesn't fix your function buttons.

Parti

Nessuna parte richiesta.

Remove wrist strap and battery. Remove wrist strap and battery.
  • Remove wrist strap and battery.

Aggiungi Commento

Remove 2 screws from each side of the camera (4 total, 0.102 in). Remove 2 screws from the bottom on the camera (0.138 in). Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.
  • Remove 2 screws from each side of the camera (4 total, 0.102 in).

  • Remove 2 screws from the bottom on the camera (0.138 in).

  • Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.

Aggiungi Commento

Gently pull off the front cover. The plate on the side should come off. Gently pull off the back cover.
  • Gently pull off the front cover.

  • The plate on the side should come off.

  • Gently pull off the back cover.

Aggiungi Commento

The cases should now be removed.
  • The cases should now be removed.

This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.

Craig Bonsignore - Replica

oh yes , i agree lol

elbala80 -

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Use the spudger to disconnect the black tab.
  • Use the spudger to disconnect the black tab.

Aggiungi Commento

Gently pull off the shutter button assembly.
  • Gently pull off the shutter button assembly.

Aggiungi Commento

Use the tweezers to disconnect the microphone cable.
  • Use the tweezers to disconnect the microphone cable.

Aggiungi Commento

The shutter button assembly should now be removed.
  • The shutter button assembly should now be removed.

Aggiungi Commento

With the spudger, flip up the black tab on the main ribbon.
  • With the spudger, flip up the black tab on the main ribbon.

Aggiungi Commento

Gently pull straight out on the ribbon to disconnect it from the logic board. Gently pull straight out on the ribbon to disconnect it from the logic board.
  • Gently pull straight out on the ribbon to disconnect it from the logic board.

Aggiungi Commento

By hand, gently unfold the function button board and lift it off the frame.
  • By hand, gently unfold the function button board and lift it off the frame.

Aggiungi Commento

Congratulations! The function button board can now be replaced.
  • Congratulations! The function button board can now be replaced.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Wyatt Chan

Membro da: 05/01/2011

235 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 3-32, Regan Winter 2011 Membro di Cal Poly, Team 3-32, Regan Winter 2011

CPSU-REGAN-W11S3G32

3 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,785