Open the battery door by sliding the tab on the battery door while pushing the battery door away from the camera. Remove batteries.
  • Open the battery door by sliding the tab on the battery door while pushing the battery door away from the camera.

  • Remove batteries.

Aggiungi Commento

Remove the three indicated .2mm screws using a Philips #00 screwdriver. Gently pull off side-panel to remove it.
  • Remove the three indicated .2mm screws using a Philips #00 screwdriver.

  • Gently pull off side-panel to remove it.

Aggiungi Commento

Remove the two indicated .2mm screws using a Philips #00 screwdriver.
  • Remove the two indicated .2mm screws using a Philips #00 screwdriver.

Aggiungi Commento

Remove the indicated .2mm screw using a Philips #00 screwdriver. Remove the three .2mm screws located on the internal side of the top panel within the battery chamber using a Philips #00 screwdriver.
  • Remove the indicated .2mm screw using a Philips #00 screwdriver.

  • Remove the three .2mm screws located on the internal side of the top panel within the battery chamber using a Philips #00 screwdriver.

Aggiungi Commento

Open 'DIGITAL A/V OUT' door on camera. Remove the two indicated .2mm screws using a Philips #00 screwdriver.
  • Open 'DIGITAL A/V OUT' door on camera.

  • Remove the two indicated .2mm screws using a Philips #00 screwdriver.

Aggiungi Commento

Grip the sides of the top panel and gently pull to separate the top panel from the camera body.
  • Grip the sides of the top panel and gently pull to separate the top panel from the camera body.

  • The top panel will not completely detach.

Aggiungi Commento

Gently pull the front and back panels apart, and use a Phillips #00 screwdriver to remove the screw connecting the panels. Gripping the top and bottom, gently pull the front panel away from the camera body to remove it.
  • Gently pull the front and back panels apart, and use a Phillips #00 screwdriver to remove the screw connecting the panels.

  • Gripping the top and bottom, gently pull the front panel away from the camera body to remove it.

Aggiungi Commento

insert wisdom here insert wisdom here
  • insert wisdom here

Aggiungi Commento

Remove the 2 mm screws from the metal plate.
  • Remove the 2 mm screws from the metal plate.

Aggiungi Commento

Pull away the metal plate, exposing the underbelly of the mode dial.
  • Pull away the metal plate, exposing the underbelly of the mode dial.

  • Be careful not to pull too hard. Metal plate should remain attached.

Aggiungi Commento

Remove the 2mm screw using the #00 Phillips screwdriver. The mode dial should fall out.
  • Remove the 2mm screw using the #00 Phillips screwdriver.

  • The mode dial should fall out.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Alicia Burns

Membro da: 13/10/2014

552 Reputazione

5 Guide realizzate

Team

Clemson, Team 2-5, Benson Fall 2014 Membro di Clemson, Team 2-5, Benson Fall 2014

CLEM-BENSON-F14S2G5

4 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 4

Tutti i Tempi: 206