Introduzione

This guide involves taking off the entire casing of the camera. It will prepare the user to perform more complicated and problem-specific repairs.

Parti

Nessuna parte richiesta.

Slide the switch on the battery cover labeled "CARD/BATT. OPEN." to the right.
  • Slide the switch on the battery cover labeled "CARD/BATT. OPEN." to the right.

  • While still holding the switch, pull the cover down, allowing it to release and open.

Aggiungi Commento

Tilt the camera slightly to allow the batteries to fall out.
  • Tilt the camera slightly to allow the batteries to fall out.

Aggiungi Commento

Press on and release the memory card to eject it.
  • Press on and release the memory card to eject it.

Aggiungi Commento

Unscrew the 5mm Phillips #00 screw from the bottom of the camera.
  • Unscrew the 5mm Phillips #00 screw from the bottom of the camera.

  • Make sure to keep the different size screws organized to make reassembling the camera simpler.

Aggiungi Commento

Unscrew the three 2mm Phillips #00 screws that are located on the bottom of the camera.
  • Unscrew the three 2mm Phillips #00 screws that are located on the bottom of the camera.

Aggiungi Commento

Remove the 4mm Phillips #00 screw that is located on the left side of the camera, if the display screen is facing you.
  • Remove the 4mm Phillips #00 screw that is located on the left side of the camera, if the display screen is facing you.

Aggiungi Commento

Take out the 4mm Phillips #00 screw under the rubber flap on the right end of the camera.
  • Take out the 4mm Phillips #00 screw under the rubber flap on the right end of the camera.

Aggiungi Commento

Remove the second battery cover on the bottom of camera. Take the silver battery out of the camera.
  • Remove the second battery cover on the bottom of camera.

  • Take the silver battery out of the camera.

Aggiungi Commento

Remove the 4mm Phillips #00 screw on the inside of the flap that hides the battery and memory card slots. Remove the light grey, plastic piece. Remove the plastic portion of the battery flap cover. The metal piece will remain attached.
  • Remove the 4mm Phillips #00 screw on the inside of the flap that hides the battery and memory card slots.

  • Remove the light grey, plastic piece.

  • Remove the plastic portion of the battery flap cover. The metal piece will remain attached.

Aggiungi Commento

Slightly pull on each side of the camera. It should loosen up and come apart. If it does not pull apart right away, use a little more force. Do not give up!
  • Slightly pull on each side of the camera. It should loosen up and come apart.

  • If it does not pull apart right away, use a little more force.

  • Do not give up!

Aggiungi Commento

Remove the back case of the camera by pulling from the top.
  • Remove the back case of the camera by pulling from the top.

  • Be careful when pulling off the case. There is a delicate gold ribbon connecting the bottom of the camera to the back case.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 19-42, Regan Winter 2013 Membro di Cal Poly, Team 19-42, Regan Winter 2013

CPSU-REGAN-W13S19G42

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 11

Tutti i Tempi: 1,338