Introduzione

In this step we will be removing the rear casing from the sewing machine. This is necessary to access the inside components of the machine.

Parti

Nessuna parte richiesta.

Place the machine on a solid surface.
  • Place the machine on a solid surface.

  • Remove the 14mm Phillips #2 screw holding on the face cover.

Aggiungi Commento

Remove the two 14mm Phillips #2 screws and two 22mm Phillips #2 screws that secure the rear casing.
  • Remove the two 14mm Phillips #2 screws and two 22mm Phillips #2 screws that secure the rear casing.

Aggiungi Commento

Lay the machine on its side.
  • Lay the machine on its side.

  • Remove the four 10mm Phillips #2 screws that hold the bottom panel in place.

  • The feet will come off with the screws.

Aggiungi Commento

Remove the bottom panel.
  • Remove the bottom panel.

Aggiungi Commento

Place the machine upright.
  • Place the machine upright.

  • Remove the rear casing.

  • You may have to wiggle the panel and pull at the same time.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Allison

Membro da: 03/02/2014

239 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 2-12, Amido Winter 2014 Membro di Cal Poly, Team 2-12, Amido Winter 2014

CPSU-AMIDO-W14S2G12

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 13

Ultimi 30 Giorni: 62

Tutti i Tempi: 986