Introduzione

Outline what you are going to teach someone how to do.

Parti

Nessuna parte richiesta.

Before beginning this installation, make sure phone is powered off . Turn phone over to the backside. Press down on the lower portion of the back cover.
  • Before beginning this installation, make sure phone is powered off .

  • Turn phone over to the backside.

  • Press down on the lower portion of the back cover.

  • Slide the lower portion down to remove the cover and reveal the battery.

Aggiungi Commento

Remove the battery from the phone.
  • Remove the battery from the phone.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver. Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver.
  • Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver.

Aggiungi Commento

Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool. Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool. Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool.
  • Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool.

Aggiungi Commento

Remove the back casing using the Plastic Opening Tool Once the back casing is removed the top two buttons are likely to pop out.
  • Remove the back casing using the Plastic Opening Tool

    • Once the back casing is removed the top two buttons are likely to pop out.

Aggiungi Commento

Locate the two 9.2mm screws on the upper inside casing Remove them using the T4 Torx Screwdriver Slide off the front casing once the screws are removed.
  • Locate the two 9.2mm screws on the upper inside casing

  • Remove them using the T4 Torx Screwdriver

  • Slide off the front casing once the screws are removed.

    • Trackball will fall out once the casing is removed.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 17-27, Amido Spring 2012 Membro di Cal Poly, Team 17-27, Amido Spring 2012

CPSU-AMIDO-S12S17G27

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 498