Introduzione

If you're internal battery dies, use this guide to replace it.

Parti

Nessuna parte richiesta.

Use a T9 Screwdriver to unscrew the two screws on the backside of the BlackBerry, one on the bottom left and one on the top right.
  • Use a T9 Screwdriver to unscrew the two screws on the backside of the BlackBerry, one on the bottom left and one on the top right.

Aggiungi Commento

Remove the backside of the device and set aside for later use.
  • Remove the backside of the device and set aside for later use.

Aggiungi Commento

Remove the rubber placement pad that sits under the battery and set aside for later use. Gently fold back the battery, making sure the small plug connecting the battery to the logic board remains intact. Extra care should be taken as this part is quite delicate and easy to damage. Remove the rubber placement pad that sits under the battery and set aside for later use. Gently fold back the battery, making sure the small plug connecting the battery to the logic board remains intact. Extra care should be taken as this part is quite delicate and easy to damage.
  • Remove the rubber placement pad that sits under the battery and set aside for later use. Gently fold back the battery, making sure the small plug connecting the battery to the logic board remains intact. Extra care should be taken as this part is quite delicate and easy to damage.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Use the T9 Screwdriver to remove the five visible screws: Top right, bottom right, middle center, bottom center, bottom left.
  • Use the T9 Screwdriver to remove the five visible screws: Top right, bottom right, middle center, bottom center, bottom left.

Aggiungi Commento

Carefully remove the board from the device by gently pushing on the screen from the front side. The battery, screen, and scroll wheel are all connected to the logic board. Be sure to support these components so they do not break. Note the placement of two additional rubber pieces that cling loosely to the logic board. It is okay to let these pieces fall loose.
  • Carefully remove the board from the device by gently pushing on the screen from the front side. The battery, screen, and scroll wheel are all connected to the logic board. Be sure to support these components so they do not break.

  • Note the placement of two additional rubber pieces that cling loosely to the logic board. It is okay to let these pieces fall loose.

    • One is located below the scrollwheel.

    • Another is located behind the screen.

Aggiungi Commento

Disconnect the power conductor by gently peeling the grey section (which is connected to the logic board) upwards.
  • Disconnect the power conductor by gently peeling the grey section (which is connected to the logic board) upwards.

Aggiungi Commento

The conductor can now be easily removed by pulling it off of the logic board.
  • The conductor can now be easily removed by pulling it off of the logic board.

Aggiungi Commento

Gently pull on the wires connecting the battery to the device until the battery disconnects. Gently pull on the wires connecting the battery to the device until the battery disconnects.
  • Gently pull on the wires connecting the battery to the device until the battery disconnects.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 33-83, Johann Spring 2010 Membro di Cal Poly, Team 33-83, Johann Spring 2010

CPSU-JOHANN-S10S33G83

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 2,141