Aggiusta la tua roba Comunità Store

Black and Decker BL3000S Circuit Board

Cosa ti serve

  1. Black and Decker BL3000S Circuit Board, Blender Base: passo 1, immagine 1 di 2 Black and Decker BL3000S Circuit Board, Blender Base: passo 1, immagine 2 di 2

    • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

    • Lift the jar straight up from the base without tilting the jar.

    Traduci

  2. Black and Decker BL3000S Circuit Board: passo 2, immagine 1 di 1

    • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

    Traduci

  3. Black and Decker BL3000S Circuit Board: passo 3, immagine 1 di 2 Black and Decker BL3000S Circuit Board: passo 3, immagine 2 di 2

    • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

    • This provides access to the base screws beneath.

    Traduci

  5. Black and Decker BL3000S Circuit Board: passo 4, immagine 1 di 1

    • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

    • Both screwdrivers must have a minimum of a three inch shank (length).

    • Screwdrivers with extenders will not fit down the access holes.

    Traduci

  6. Black and Decker BL3000S Circuit Board: passo 5, immagine 1 di 1

    • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

    Traduci

  7. Black and Decker BL3000S Circuit Board, Circuit Board: passo 6, immagine 1 di 1

    • Once you have the base removed, the circuit board should be clearly visible inside.

    Traduci

  8. Black and Decker BL3000S Circuit Board: passo 7, immagine 1 di 2 Black and Decker BL3000S Circuit Board: passo 7, immagine 2 di 2

    • Remove the four screws located on the circuit board.

    • Two are on the left side.

    • Two are on the right side.

    Traduci

  9. Black and Decker BL3000S Circuit Board: passo 8, immagine 1 di 1

    • Remove the following soldered connections with a soldering iron:

    • Motor wires

    • Power cord wires

    Traduci

  10. Black and Decker BL3000S Circuit Board: passo 9, immagine 1 di 1

    • Lift the circuit board straight up to remove it from the base.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

con 4 altri collaboratori

Andrew

Membro da: 10/04/12

209 Reputazione

4 Guide realizzate

Distintivi: 10

+7 altri distintivi

Team

Cal Poly, Team 6-34, Regan Fall 2012 Membro di Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 Membri

6 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 4

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 38

Tutti i Tempi: 4,679