Introduzione

In this step we will be removing all parts necessary to reach the speaker inside each headset. Remember that you can repeat these same steps for each side of the headset if either side needs replacement.

Pull one corner of the pad to release it from the headset. Pull the rest of the ear pad off.
  • Pull one corner of the pad to release it from the headset.

  • Pull the rest of the ear pad off.

Aggiungi Commento

Locate the four 4.5 mm Philips #0 screws on the panel shown. Remove them using a Phillips #0 head screwdriver.
  • Locate the four 4.5 mm Philips #0 screws on the panel shown.

  • Remove them using a Phillips #0 head screwdriver.

  • Remove the panel.

Aggiungi Commento

Using either your fingers or a plastic opening tool, pry off the speaker cover. Using either your fingers or a plastic opening tool, pry off the speaker cover.
  • Using either your fingers or a plastic opening tool, pry off the speaker cover.

Aggiungi Commento

Locate the four 4.5 mm Philips #0 screws as shown on the speaker housing.
  • Locate the four 4.5 mm Philips #0 screws as shown on the speaker housing.

  • Remove the four screws using a Phillips #0 head screwdriver.

Aggiungi Commento

Remove the housing to reveal the speaker.
  • Remove the housing to reveal the speaker.

  • Make sure not to break the small wire holding the two portions together.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Donavan Feliz

Membro da: 22/01/2015

371 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 20-18, Maness Winter 2015 Membro di Cal Poly, Team 20-18, Maness Winter 2015

CPSU-MANESS-W15S20G18

4 Membri

5 Guide realizzate

Where do you buy the replacement speaker ? Thanks.

Steve Rosam - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 5

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 54

Tutti i Tempi: 2,821