Introduzione

Replacing the USB port for the display.

Parti

Nessuna parte richiesta.

Lay the display facing down with the stand away from you. Remove the three size 2.0 hex screws on the swing arm and remove the swing arm as well as the plastic shield under it.
  • Lay the display facing down with the stand away from you.

  • Remove the three size 2.0 hex screws on the swing arm and remove the swing arm as well as the plastic shield under it.

Aggiungi Commento

Remove the size 2.5 hex screws from each corner that connects the panels to the display and remove them.
  • Remove the size 2.5 hex screws from each corner that connects the panels to the display and remove them.

Aggiungi Commento

Rotate the display so the legs of the display are now facing you
  • Rotate the display so the legs of the display are now facing you

  • Grip the top of the clear panel and lift it upwards, and pull the ADC cable through the hole.

Aggiungi Commento

Remove the grey back panel by lifting the bottom and pulling the ADC cable through the hole.
  • Remove the grey back panel by lifting the bottom and pulling the ADC cable through the hole.

Aggiungi Commento

The next layer will be a shiny metal panel, which might have some stickers. Make sure to remove these stickers.
  • The next layer will be a shiny metal panel, which might have some stickers. Make sure to remove these stickers.

Aggiungi Commento

Now locate and remove the lone screw holding the EMI shield to the display
  • Now locate and remove the lone screw holding the EMI shield to the display

Aggiungi Commento

Now that the screw has been removed, slide the panel towards your body and lift it out. You may need to remove the clear USB port cover to remove the metal EMI shield.
  • Now that the screw has been removed, slide the panel towards your body and lift it out.

    • You may need to remove the clear USB port cover to remove the metal EMI shield.

Aggiungi Commento

To remove the USB port, remove these four screws holding down the port and metal brackets.
  • To remove the USB port, remove these four screws holding down the port and metal brackets.

    • There may be a zip tie you need to cut that is attaching the USB unit to the display

Aggiungi Commento

Remove the cable from the logic board that is connecting the USB port.
  • Remove the cable from the logic board that is connecting the USB port.

Aggiungi Commento

Remove the USB port
  • Remove the USB port

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Andrew Tsao

Membro da: 19/01/2010

159 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 3-20, Maness Winter 2010 Membro di Cal Poly, Team 3-20, Maness Winter 2010

CPSU-MANESS-W10S3G20

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 2,748