Introduzione

Replace the speaker in your Acer Iconia Tab 500.

Parti

Nessuna parte richiesta.

To start, gently separate one corner of the case using the black spudger.
  • To start, gently separate one corner of the case using the black spudger.

Aggiungi Commento

Once you have successfully pried the spudger in between the front case and back case, continue do so around the entire tablet until the back case is completely disconnected.
  • Once you have successfully pried the spudger in between the front case and back case, continue do so around the entire tablet until the back case is completely disconnected.

Aggiungi Commento

Locate the 4 screws and cable that hold in the two speakers.
  • Locate the 4 screws and cable that hold in the two speakers.

    • Use the Phillips #1 screwdriver to remove these 2mm black screws.

    • Remove the 2mm silver screws.

      • Not all 4 screws are going to be the same kind. This will not affect the speaker replacement.

    • Connector Cable

Aggiungi Commento

Carefully remove the connector cable by pushing on the rim of black plastic insert.
  • Carefully remove the connector cable by pushing on the rim of black plastic insert.

Aggiungi Commento

Unfortunately, the top speaker is a wedged under the motherboard.
  • Unfortunately, the top speaker is a wedged under the motherboard.

  • To get this speaker out, use the spudger and gently pry it out.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Kyle Libby

Membro da: 07/04/2014

932 Reputazione

13 Guide realizzate

Team

Cal Poly, Team 7-23, Regan Spring 2014 Membro di Cal Poly, Team 7-23, Regan Spring 2014

CPSU-REGAN-S14S7G23

4 Membri

16 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 23

Tutti i Tempi: 1,553