Introduzione

Upgrade or replace RAM.

Remove the screws on the large panel. Lift up the panel.
  • Remove the screws on the large panel.

  • Lift up the panel.

Aggiungi Commento

The RAM slots are located in the corner opposite to the cooling fan. To remove existing RAM cards: there are clips holding the sides of each card. Simultaneously spread both right and left clip and the card will pop upward. Then it can easily be pulled out. Slide in the RAM at a 45 degree angle.
  • The RAM slots are located in the corner opposite to the cooling fan.

  • To remove existing RAM cards: there are clips holding the sides of each card. Simultaneously spread both right and left clip and the card will pop upward. Then it can easily be pulled out.

  • Slide in the RAM at a 45 degree angle.

  • Press down on the RAM until it snaps into place.

  • A good amount of pressure is needed to snap it in place.

  • Install the RAM in the left (lower) slot before installing RAM in the right (upper) slot

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 7 persone hanno completato questa guida.

Brad Rollinson

Membro da: 29/09/2010

1.089 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 14-39, Forte Fall 2010 Membro di Cal Poly, Team 14-39, Forte Fall 2010

CPSU-FORTE-F10S14G39

5 Membri

9 Guide realizzate

being a novice ram replacement i found this to be exactly what i needed to know thankyou very much.

bruce johnson - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 12

Ultimi 30 Giorni: 46

Tutti i Tempi: 14,456