Introduzione

Here, the back cover will be removed followed by the secondary back panel. Once this is completed and the motherboard is visible, the vibration motor is accessible and can be replaced.

Using the blue plastic opening tool, insert the tip into the crease between the back cover and the phone and pry it upwards. Work your way around the phone until the entire back cover is loose.
  • Using the blue plastic opening tool, insert the tip into the crease between the back cover and the phone and pry it upwards.

  • Work your way around the phone until the entire back cover is loose.

Aggiungi Commento

Remove the thirteen 3.6 mm screws using the torx T5 bit in the screwdriver. Remove the thirteen 3.6 mm screws using the torx T5 bit in the screwdriver.
  • Remove the thirteen 3.6 mm screws using the torx T5 bit in the screwdriver.

Aggiungi Commento

Using the blue plastic opening tool, insert the tip into the crease between the mid-frame and the phone and pry it upwards. Work your way around the phone until the entire back cover is loose and remove the mid-frame.
  • Using the blue plastic opening tool, insert the tip into the crease between the mid-frame and the phone and pry it upwards.

  • Work your way around the phone until the entire back cover is loose and remove the mid-frame.

Aggiungi Commento

Using a spudger, pry the vibration motor connector from the motherboard.
  • Using a spudger, pry the vibration motor connector from the motherboard.

Aggiungi Commento

Gently pry the vibration motor upwards using the spudger.
  • Gently pry the vibration motor upwards using the spudger.

  • The vibration motor is held down by some adhesive, force might be needed to remove it.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Ryan

Membro da: 14/05/2012

223 Reputazione

2 Guide realizzate

Team

USF Tampa, Team 8-4, Leahy Fall 2014 Membro di USF Tampa, Team 8-4, Leahy Fall 2014

USFT-LEAHY-F14S8G4

4 Membri

5 Guide realizzate

That is not the speaker, that is the motor for the vibrate functions...

The speaker is located in the plastic back of the housing near the camera hole.

tee1331 - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,193