Introduzione

Replacing the spark plugs in your Malibu can keep it running strong. New spark plugs will produce a stronger spark than older spark plugs allowing your engine to run smoother and more efficient.

Use the 1/2" socket to loosen and remove the four bolts and washers on the spark plug cover labeled 2.4L Twin Cam. These four bolts should be torqued to 18 ft-lbs when putting the spark plug cover back on. These four bolts should be torqued to 18 ft-lbs when putting the spark plug cover back on.
  • Use the 1/2" socket to loosen and remove the four bolts and washers on the spark plug cover labeled 2.4L Twin Cam.

    • These four bolts should be torqued to 18 ft-lbs when putting the spark plug cover back on.

Aggiungi Commento

With a flathead screwdriver remove the ignition coil electrical connector on the right side of spark plug cover. Be careful while disconnecting the ignition coil electrical connector as it may break. Be careful while disconnecting the ignition coil electrical connector as it may break.
  • With a flathead screwdriver remove the ignition coil electrical connector on the right side of spark plug cover.

  • Be careful while disconnecting the ignition coil electrical connector as it may break.

Aggiungi Commento

Remove the spark plug cover. Remove the spark plug cover.
  • Remove the spark plug cover.

Aggiungi Commento

When working with compressed air, wear safety glasses to protect your eyes from flying debris.
  • When working with compressed air, wear safety glasses to protect your eyes from flying debris.

  • Use compressed air to clear any debris from the area around the spark plugs.

    • Any particles that fall into the cylinder could cause serious engine damage.

  • Use a 5/8" spark plug socket with an extension to loosen and remove the spark plugs.

Aggiungi Commento

Before installing the new spark plugs check that the spark plugs' gap is between 0.048 and 0.052 inches. If it needs to be widened, use a gap setter to increase the size of the gap until it reaches the desired width. If it needs to be widened, use a gap setter to increase the size of the gap until it reaches the desired width.
  • Before installing the new spark plugs check that the spark plugs' gap is between 0.048 and 0.052 inches.

  • If it needs to be widened, use a gap setter to increase the size of the gap until it reaches the desired width.

Aggiungi Commento

Wedge the new spark plugs into a 5/8'' spark plug socket.
  • Wedge the new spark plugs into a 5/8'' spark plug socket.

  • Place the spark plug into the cylinder using the socket and hand tighten the spark plugs as much as possible.

  • Tighten the spark plugs to 13 ft-lbs with a torque wrench.

  • Do not over tighten spark plugs. This could strip out the threaded holes in the head.

You mention all but the plug size or Pat number

margaret groot-koerkamp - Replica

Conclusione

To reassemble your device, follow Steps 1-3 in reverse order.

Altre 3 persone hanno completato questa guida.

Sank Yang

Membro da: 03/10/2012

345 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 9-15, Amido Fall 2012 Membro di Cal Poly, Team 9-15, Amido Fall 2012

CPSU-AMIDO-F12S9G15

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 17

Ultimi 7 Giorni: 110

Ultimi 30 Giorni: 420

Tutti i Tempi: 23,602