Skip to main content

Traduzione in corso passo 6

Step 6
No image
Re-enable SIP
  • Unless you have a compelling reason otherwise, you'll want to reenable SIP. Once again, you'll have to go into Recovery Mode just like you did before and open the Terminal.

  • Enter the following command

  • csrutil enable

  • Reboot the machine and let it load to the desktop. Open a new terminal window and enter the following command to check the status of SIP

  • csrutil status

  • If all was successful, you should get a line back that reads:

  • System Integrity Protection status: enabled.

特別な理由がない限り、SIPを再度有効にしましょう。 もう一度、以前と同じように回復モードに入り、ターミナルを開きます。


csrutil enable


csrutil status


System Integrity Protection status: enabled.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.