Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 3

Passo 3
Nessuna immagine
Install parts and fill with oil
  • Place a little oil on the rubber gasket of the new oil filter. Then install the new filter only hand-tighten.

  • Tighten the new oil filter one-half turn further than hand-tight, using an oil filter wrench.

  • The oil drain plug has a crush washer that needs to be replaced. Then put the plug back on and tighten it to 29 ft-lb of torque using a torque wrench. (It is best to under-tighten the oil drain plug. If it is over-tightened you may crack the oil pan!)

  • Pour 3 quarts (not all 4) into the oil tank.

  • Check for leaks.

  • Remove the used oil in the drain pan under the car. Clean up under the car.

  • Lower your vehicle so it is resting on the ground and is level.

  • Use the dipstick to check the oil level. Add a little of the remaining oil, and check the dipstick again. Continue adding some oil until the dipstick shows the oil level is full.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.