Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Giapponese

Traduzione in corso passo 1

Passo 1
Peel off the four black tamper-evident stickers covering the heat sink mounting screws. Remove the four T10 screws that secure the heat sink from the backside of the logic board.
  • Peel off the four black tamper-evident stickers covering the heat sink mounting screws.

  • Remove the four T10 screws that secure the heat sink from the backside of the logic board.

  • During reassembly, tighten these screws one full turn at a time, alternating in a cross pattern. This will gradually increase the clamping pressure evenly across the surface of the CPU. Continue gradually tightening the screws until they're snug and the entire spring plate lays flat against the logic board.

ヒートシンクを固定しているネジの上に貼られた、黒いボイドステッカーを剥がします。

ロジックボードの裏側からヒートシンクを固定しているT10ネジを4本外します。

再組み立ての際は、これらのネジを一度に1回転ずつ、十字パターンで交互に締めていきます。 これによりCPUの表面全体のクランプ圧力を均等に上昇させることができます。 ネジがきちんと締まり、スプリングプレート全体がロジックボードに対して水平になるまで、徐々にネジを締めていきます。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.