Salta al contenuto principale

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte 14le guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 7

Passo 7
The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed. As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.
  • The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed.

  • As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.

  • Use the opening picks to slice through any remaining adhesive and open the phone slightly.

  • If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Disconnect the connector with the point of a spudger before proceeding.

  • During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket. Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.

  • Remove the glass from the phone.

Il cavo del sensore impronte digitali collega il telefono al vetro posteriore vicino alla camera principale. Il cavo è molto corto e dovrebbe disconnettersi quando rimuovi il vetro posteriore.

Mentre sollevi il vetro, dai un occhiata dentro per verificare che il cavo arancio con il connettore blu si sia disconnesso.

Usa i plettri di apertura per tagliare ogni adesivo residuo e aprire leggermente il telefono.

Se il sensore impronte digitali sembra essersi impigliato o rimane in tensione, non continuare ad aprire il telefono. Disconnetti il connettore con la punta di uno spudger prima di procedere.

Rimuovi il vetro dal telefono.

[* icon_note] The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed.
[* icon_caution] As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.
[* black] Use the opening picks to slice through any remaining adhesive and open the phone slightly.
[* icon_caution] If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Disconnect the connector with the point of a spudger before proceeding.
[* icon_reminder] During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket. Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.
[* black] Remove the glass from the phone.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.