Salta al contenuto principale

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte 14le guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 1

Passo 1
Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
  • Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.

  • Heat an iOpener and apply it to a long edge of the S8 for about 2 minutes.

  • You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the OLED display and internal battery are both susceptible to heat damage.

  • As you're waiting for the adhesive to soften, move on and read the following step to get an idea of where to pry.

Applica un iOpener riscaldato su uno dei bordi lunghi dell'S8 per circa due minuti.

Dovrai forse scaldare e applicare di nuovo l'iOpener più volte per scaldare a sufficienza il telefono. Segui le istruzioni dell'iOpener per evitare il surriscaldamento.

Mentre aspetti che l'adesivo si ammorbidisca, vai avanti e leggi il passo seguente per farti un'idea del punto migliore per far leva.

[* icon_note] Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
[*
black] Apply a heated iOpener[guide|25705|Heat an iOpener|new_window=true] and apply it to a long edge of the S8 for about 2 minutes.
[* icon_note] Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
[*
black] Apply a heated iOpener[guide|25705|Heat an iOpener|new_window=true] and apply it to a long edge of the S8 for about 2 minutes.
[* icon_note] You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.
[* icon_caution] A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the OLED display and internal battery are both susceptible to heat damage.
[* icon_note] As you're waiting for the adhesive to soften, move on and read the following step to get an idea of where to pry.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.