Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Cinese

Traduzione in corso passo 4

Passo 4
Use a T8 Torx security screwdriver to remove the eleven 10mm silver screws from the metal plate. Use a Phillips #1 screwdriver to remove the eleven 4mm black screws from the metal plate. Use a spudger to disconnect the three antenna cables (two black and one white) by prying them straight up from their sockets.
  • Use a T8 Torx security screwdriver to remove the eleven 10mm silver screws from the metal plate.

  • Use a Phillips #1 screwdriver to remove the eleven 4mm black screws from the metal plate.

  • Use a spudger to disconnect the three antenna cables (two black and one white) by prying them straight up from their sockets.

使用一个 T8 安全梅花螺丝从金属板上移除11个 10mm 银色螺丝。

使用一个 #0 十字螺丝从金属板上移除11个 4mm 黑色螺丝。

拔下通过金属板连接到主板小部分的三根电缆。

电缆接口可能会很锋利。

[* red] Use a T8 Torx security screwdriver to remove the eleven 10mm silver screws from the metal plate.
-[* orange] Use a Phillips #0 screwdriver to remove the eleven 4mm black screws from the metal plate.
-[* yellow] Pull off the three cables connected to the small portion of the motherboard showing through the metal plate.
-[* icon_caution] The cable connectors can be sharp.
+[* orange] Use a Phillips #1 screwdriver to remove the eleven 4mm black screws from the metal plate.
+[* yellow] Use a spudger to disconnect the three antenna cables (two black and one white) by prying them straight up from their sockets.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.