Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Inglese
Francese

Traduzione in corso passo 7

Passo 7
Flip up the retaining flaps on each end of the I/O board ribbon cable ZIF connector. Carefully pull the the I/O board ribbon cable from its sockets. Remove the two 4.6 mm screws holding the hard drive in place.
  • Flip up the retaining flaps on each end of the I/O board ribbon cable ZIF connector.

  • Carefully pull the the I/O board ribbon cable from its sockets.

  • Remove the two 4.6 mm screws holding the hard drive in place.

Relevez les rabats de retenue à chaque extrémité du connecteur ZIF du câble à ruban de la carte d'E / S.

Tirez délicatement le câble ruban de la carte d'E / S de ses prises.

Retirez les deux vis de 4,6 mm maintenant le disque dur en place.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.