Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 4

Passo 4
Peel off a few feet of the adhesive backing on the roll of new bar tape. Affix the center of the end of the tape to the edge of the drop bar so that half of the width of the tape hangs over the end of the bar. Begin to snugly wrap the tape up the handlebar, pulling the tape up and over the handlebar toward the bicycle.
  • Peel off a few feet of the adhesive backing on the roll of new bar tape.

  • Affix the center of the end of the tape to the edge of the drop bar so that half of the width of the tape hangs over the end of the bar.

  • Begin to snugly wrap the tape up the handlebar, pulling the tape up and over the handlebar toward the bicycle.

  • As you wrap, peel off more adhesive backing as needed and overlap each new layer of tape by one half of its width.

  • When wrapping the tape around curves in the handlebars, allow for more overlap on the inside of the curve and less overlap on the outside of the curve.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.