Salta al contenuto principale
Inglese
Tedesco

Traduzione in corso passo 5

Passo 5
Loosen all screws of the hangers along the frame which hold the saddle cable. Bring the front end with the switch to the bar by pulling it through the hangers along the frame. Take care of the other cables around your bar. Position the lever on the right side of your bar and tighten it's screw loosely. Bring it into a comfortable position for your riding stance and tighten its bolt with the torque wrench  to 5-6 Nm.
  • Loosen all screws of the hangers along the frame which hold the saddle cable.

  • Bring the front end with the switch to the bar by pulling it through the hangers along the frame. Take care of the other cables around your bar.

  • Position the lever on the right side of your bar and tighten it's screw loosely. Bring it into a comfortable position for your riding stance and tighten its bolt with the torque wrench to 5-6 Nm.

Lockere alle Schrauben der Klemmen, welche das Sattelkabel entlang des Rahmens halten.

Anschließend kannst du das vordere Ende des Kabels zum Lenker führen, indem du es durch die Klemmen entlang des Rahmen ziehst. Achte dabei darauf dich nicht mit anderen Kabeln im Bereich des Lenkers zu verheddern.

Positioniere den Knopf für den Sattel an der rechten Seite des Lenkers neben dem Bremshebel. Ziehe seine Schraube dort locker an. Bringe ihn anschließend in einen angenehmen Winkel für die Fahrposition deiner Hand und zieh dann die Schraube mit einem Drehmomentschlüssel auf 5-6 Nm fest.

[* black] Loosen all screws of the hangers along the frame which hold the saddle cable.
[* black] Bring the front end with the switch to the bar by pulling it through the hangers along the frame. Take care of the other cables around your bar.
[* black] Position the lever on the right side of your bar and tighten it's screw loosely. Afterwards bringBring it into a comfortable position for your riding stance and tighten its bolt with the torque wrench to 5-6 Nm.
[* black] Position the lever on the right side of your bar and tighten it's screw loosely. Afterwards bringBring it into a comfortable position for your riding stance and tighten its bolt with the torque wrench to 5-6 Nm.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.