Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 3

Passo 3
Position the handlebar centered in the stem clamp and put the faceplate back on. Retighten the bolts of the faceplate while the bar is in a adequate position with slightly pointing down brake levers, until they hold the bar. Now tighten the bolts in a cross pattern, starting with upper left going to lower right, then upper right going to lower left. The torque wrench value for this should be around 8 Nm.
  • Position the handlebar centered in the stem clamp and put the faceplate back on.

  • Retighten the bolts of the faceplate while the bar is in a adequate position with slightly pointing down brake levers, until they hold the bar.

  • Now tighten the bolts in a cross pattern, starting with upper left going to lower right, then upper right going to lower left. The torque wrench value for this should be around 8 Nm.

  • Make sure the upper and lower gaps between faceplate and stem body are parallel and with an identical width.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.