Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Giapponese

Traduzione in corso passo 4

Passo 4
Prepare your component for soldering by removing any excess solder from the contacts. The contacts should be clean enough to pass through the solder pad holes.
  • Prepare your component for soldering by removing any excess solder from the contacts. The contacts should be clean enough to pass through the solder pad holes.

  • Run the soldering iron tip down the lengths of each contact to wipe the solder away from the component. Clean the iron's tip between strokes by wiping it against a moist sponge.

  • Excessive heat will damage the components, so do not apply the soldering iron to the component for long amounts of time.

部品の端子から余分なはんだを完全に除去して、はんだ付けを行う準備をします。端子は、はんだパッドのホールを通過できる程度にきれいにしておく必要があります。

はんだごての先端を、それぞれの端子の長手方向になぞらせて、はんだを部品から除去します。1回なぞるごとに、湿ったスポンジに押し当ててぬぐい、はんだごての先端の汚れを取ります。

加熱しすぎると部品が損傷するため、長時間はんだごてを部品に当てないでください。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.