Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Giapponese

Traduzione in corso passo 14

Passo 14
To solder the new leads to the board, place the bare end of one lead onto the bead of solder on its corresponding solder pad.
  • To solder the new leads to the board, place the bare end of one lead onto the bead of solder on its corresponding solder pad.

  • Press the tip of the soldering iron onto the solder bead until it melts.

  • Slide the exposed end of the lead into the liquid solder until it is in the center of the bead, then remove the soldering iron.

  • Continue with the other connections the same way, taking special care not to solder two of the pads together.

新しいリードを基板にはんだ付けするには、対応するはんだパッドのはんだの玉に、被覆が剥がれているリードを当てます。

はんだごての先端を、はんだの玉に押し当てて溶かします。

露出したリードの端部を液体化したはんだに差し込み、はんだの玉の中心までスライドさせてから、はんだごてを離します。

隣接する2つのパッドをはんだで接続してしまわないように、慎重に他の接点にも同じ方法で作業を行います。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.