Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.
Traduzione in corso passo 14
Passo 14
-
To solder the new leads to the board, place the bare end of one lead onto the bead of solder on its corresponding solder pad.
-
Press the tip of the soldering iron onto the solder bead until it melts.
-
Slide the exposed end of the lead into the liquid solder until it is in the center of the bead, then remove the soldering iron.
-
Continue with the other connections the same way, taking special care not to solder two of the pads together.
I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.