Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Olandese

Traduzione in corso passo 11

Passo 11
For the last section, battery leads will be soldered to surface-mount solder pads. These type of joints are harder to solder because the lead has no solid anchor point (such as a thru-hole) to hold it in place during soldering.
Advanced Guide
  • For the last section, battery leads will be soldered to surface-mount solder pads. These type of joints are harder to solder because the lead has no solid anchor point (such as a thru-hole) to hold it in place during soldering.

  • To de-solder the joint, place a solder wick on top of the existing solder ball and press down on the solder wick with the soldering iron.

  • Once the solder melts and flows into the wick, remove the wick from the joint.

  • Repeat the same procedure on the remaining leads.

  • When a section of solder wick is saturated with solder, it should be trimmed and discarded.

Dit laatste deel van de handleiding laat zien hoe we batterijverbindingen solderen op soldeerverbindingen die óp de printplaat zitten. Deze zijn in het Engels bekend als "surface-mount solder pads".

Om de verbinding te de-solderen, plaats je een desoldeerdraad bovenop de bestaande soldeerverbinding en druk je de draad met je soldeerbout omlaag.

Als de soldeertin eenmaal smelt en aan het draad blijft plakken, verwijder je de draad van de verbinding.

Herhaal dezelfde procedure op de overige soldeerresten.

Als een deel van de desoldeerdraad vol zit met soldeertin kun je deze afknippen en weggooien.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.