Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Olandese

Traduzione in corso passo 1

Passo 1
To start, let's solder a large component held to a circuit board with thru-hole solder pads.
Beginning Guide
  • To start, let's solder a large component held to a circuit board with thru-hole solder pads.

  • A capacitor was already removed from the two solder pads. Each pad was heated while the capacitor was pulled away from the board.

  • Notice how the solder holes are completely covered with solder. Opening these holes -- so the capacitor lead can be pushed through -- will greatly simplify installation.

Laten we, om te beginnen, een groot onderdeel op een printplaat solderen door middel van thru-hole soldeerverbindingen.

Er was al een condensator van de twee soldeerverbindingen verwijderd. Ieder verbinding was verwarmd terwijl de condensator van het bord afgetrokken werd.

Je kunt hier goed zien in hoeverre de twee soldeergaten nog steeds bedekt zijn met soldeertin. Het openen van deze gaten, zodat de condensatorverbinding erdoorheen geduwd kan worden, zal het bevestigen erg vergemakkelijken.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.