Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Francese

Traduzione in corso passo 1

Passo 1
To start, let's solder a large component held to a circuit board with thru-hole solder pads.
Beginning Guide
  • To start, let's solder a large component held to a circuit board with thru-hole solder pads.

  • A capacitor was already removed from the two solder pads. Each pad was heated while the capacitor was pulled away from the board.

  • Notice how the solder holes are completely covered with solder. Opening these holes -- so the capacitor lead can be pushed through -- will greatly simplify installation.

Pour commencer, soudons un grand composant traversant fixé sur un circuit imprimé via des trous traversants.

Un condensateur a déjà été retiré des deux pastilles de soudure. Chaque pastille a été chauffée pendant que le condensateur était retiré de la carte.

Notez que les trous des pastilles de soudure sont complètement recouverts d'étain. Débouchons ces trous – pour que les pattes du composant puissent passer à travers – cela en simplifiera grandement l'installation.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.