On the display assembly, apply the 6mm x 230mm strips, red side up, to the flange between the bumper and screen on the left and right sides.
Tip: Unpeel about an inch of the white backing from the adhesive and fold the backing to the side. Apply this exposed adhesive carefully to the lower corner. Then, with the rest of the white backing on the adhesive, locate the position of the upper corner. Hold that position with one hand while peeling the backing off with the other.
I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.
Riga successiva
Riga precedente
Inserisci una nuova riga sotto
Inserisci una nuova riga sopra
Crea rientro riga corrente
Riduci rientro riga corrente
Elimina riga corrente
Passa alla fase successiva.
Passa alla fase precedente.
Apri aiuto