Aggiusta le tue cose Community Store

Remplacement du haut-parleur du Teenage Engineering OP-1

Torna alla Guida
Inglese
Francese
Passo successivo

Traduzione in corso passo 1

Passo 1
Teenage Engineering OP-1 Speaker Replacement: passo 0, immagine 1 di 3 Teenage Engineering OP-1 Speaker Replacement: passo 0, immagine 2 di 3 Teenage Engineering OP-1 Speaker Replacement: passo 0, immagine 3 di 3

  • Disconnect the speaker by using a spudger and lifting the connector up.

  • The cables run through a small notch and are glued in place.

  • Now is the time to check the new speaker. Connect it and turn on the OP-1 to make some sounds.

  • If everything is fine, pull the cables from the old speaker out of their recess.

Déconnectez le haut-parleur en soulevant le connecteur avec une spatule (spudger).

Les câbles passent à travers une petite encoche et sont collés en place.

Il est temps maintenant de vérifier le nouveau haut-parleur. Connectez-le, allumez l'OP-1 et faites un peu de musique.

Si tout va bien, retirez les câbles de l'ancien haut-parleur de leur emplacement.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.