Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 13

Passo 13
Make sure the battery is disconnected before you disconnect or reconnect the cable in this step. Use a spudger or a fingernail to disconnect the display data cable connector.
  • Make sure the battery is disconnected before you disconnect or reconnect the cable in this step.

  • Use a spudger or a fingernail to disconnect the display data cable connector.

  • When reassembling your phone, the display data cable may pop off its connector. This can result in white lines or a blank screen when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery connector.

Achte darauf, dass der Akku abgesteckt ist, bevor du die Kabel absteckst oder wieder ansteckst.

Trenne den Display Datenkabelstecker mit einem Spudger oder einem Fingernagel.

Wenn du dein Mobiltelefon wieder zusammenbaust, springt das Datenkabel möglicherweise vom Stecker ab. Dies kann in weißen Linien oder einem schwarzen Bildschirm resultieren, wenn du dein Mobiltelefon wieder anmachst. Wenn das passiert, schließe das Kabel einfach wieder an und starte dein Mobiltelefon erneut.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.