Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 1

Passo 1
Remove the white tape from either end of the rear of the CCFL assembly. Carefully remove about 15-20mm of heat shrink from the CCFL cable to allow the end cap to be removed, making sure you DO NOT cut or nick the wire insulation. The wires have a HIGH VOLTAGE applied during operation and the insulation may break down if damaged causing a short
  • Remove the white tape from either end of the rear of the CCFL assembly.

  • Carefully remove about 15-20mm of heat shrink from the CCFL cable to allow the end cap to be removed, making sure you DO NOT cut or nick the wire insulation.

  • The wires have a HIGH VOLTAGE applied during operation and the insulation may break down if damaged causing a short

  • While holding the assembly, slowly and gently pull the THICK wires up and out of the slots in the white rubber cap.

  • Pull the wires one at a time ensuring you don't flex the CCFL and break it.

  • This will reveal the pins and solder joints.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.