Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 4

Passo 4
Here is the external connector to be rewired. It's attached with 4 #00 JIS screws and is not soldered to the pads on the logic board. Rather than cutting traces and connecting directly to the pads, I covered them with a piece of Kapton and made  new 'pads' with two strips of copper tape. There is a little IC that you will need to run over, but this step is very easy (and reversible). Rather than cutting traces and connecting directly to the pads, I covered them with a piece of Kapton and made  new 'pads' with two strips of copper tape. There is a little IC that you will need to run over, but this step is very easy (and reversible).
  • Here is the external connector to be rewired. It's attached with 4 #00 JIS screws and is not soldered to the pads on the logic board.

  • Rather than cutting traces and connecting directly to the pads, I covered them with a piece of Kapton and made new 'pads' with two strips of copper tape. There is a little IC that you will need to run over, but this step is very easy (and reversible).

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.