Skip to main content

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte 2le guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 6

Step 6
Prepare an iOpener and lay it over the lower edge of the digitizer to loosen the adhesive holding the home button gasket in place. Wait about two minutes before moving on to ensure the adhesive has adequate time to soften. Flip the digitizer panel over and gently push the home button up out of its slot in the front panel.
  • Prepare an iOpener and lay it over the lower edge of the digitizer to loosen the adhesive holding the home button gasket in place.

  • Wait about two minutes before moving on to ensure the adhesive has adequate time to soften.

  • Flip the digitizer panel over and gently push the home button up out of its slot in the front panel.

  • Push slowly and apply just enough pressure to slowly separate the gasket from the glass—if you push too hard the gasket will rip.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.