Aggiusta le tue cose Community Store

Remplacement de la carte mère du Nikon COOLPIX P500

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Torna alla Guida
Inglese
Francese
Passo precedente Passo successivo

Traduzione in corso passo 3

Passo 3
Nikon COOLPIX P500 Motherboard Replacement: passo 0, immagine 1 di 2 Nikon COOLPIX P500 Motherboard Replacement: passo 0, immagine 2 di 2

  • Separate the two parts of the body of the camera slightly.

  • Release the two cables by lifting up their respective clips with a spudger.

  • Make sure not to pull too hard because there are connector ribbons.

  • Detach the connector ribbons before fully separating the camera into two pieces.

  • These pictures were taken after the connector ribbons were released and the camera was separated into two parts. You will need to release the connector ribbons while the camera is still in one piece before you can separate it like the pictures.

Séparez légèrement les deux parties du corps de l'appareil photo.

Libérez les deux câbles en soulevant leurs clips respectifs avec une spatule.

Assurez-vous de ne pas tirer trop fort car il y a des rubans de connexion.

Détachez les rubans de connexion avant de séparer complètement l'appareil photo en deux.

Ces photos ont été prises après la libération des rubans de connexion et la séparation de l'appareil photo en deux parties. Vous devrez libérer les rubans de connexion pendant que l'appareil photo est toujours en un seul morceau avant de pouvoir le séparer comme sur les photos.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.