Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Spagnolo

Traduzione in corso passo 4

Passo 4
Insert the flat end of a spudger between the upper and lower case where they meet at the rear of the side vent opening. There is a strong plastic clip connecting the two case halves (the first of many), so you'll need to use quite a bit of force.
  • Insert the flat end of a spudger between the upper and lower case where they meet at the rear of the side vent opening.

  • There is a strong plastic clip connecting the two case halves (the first of many), so you'll need to use quite a bit of force.

  • Leave the spudger in place until you open the case completely. The clips are very springy and may cause the case to snap shut while you're working.

Inserta el extremo plano de un spudger entre la carcasa superior e inferior donde se encuentran en la parte posterior de la abertura de ventilación lateral.

Hay un clip de plástico fuerte que conecta las dos mitades de la carcasa (la primera de muchas), por lo que deberás usar bastante fuerza.

Deja el spudger en su lugar hasta que abra la caja por completo. Los clips son muy elásticos y pueden hacer que la carcasa se cierre mientras trabajas.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.