Salta al contenuto principale
Inglese
Spagnolo

Traduzione in corso passo 3

Passo 3
Set the heat gun to "Low", and let it run for a few seconds to reach operating temperature.
  • Set the heat gun to "Low", and let it run for a few seconds to reach operating temperature.

  • Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot.

  • This will prevent damage to the board caused by localized thermal expansion.

Ajusta la pistola de calor a "Baja" y déjala funcionar durante unos segundos para alcanzar la temperatura de funcionamiento.

Sosteniendo la placa base en posición vertical, calienta toda la placa con la pistola de calor. El tablero debe estar tibio, pero no demasiado caliente.

Esto evitará daños a la placa causados ​​por la expansión térmica localizada.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.