Salta al contenuto principale

Kenwood Chef: Replacing the SER1018 Planetary set

Francese
Inglese

Informazioni Guida

= Fatto = Incompleto

      Passi guida

      Passo 1 — Remove the locking latch knob

      Remove the button

      Passo 2 — Remove the sun gear

      Unscrew the hex nut

      Passo 3 — Bottom of the machine

      Remove the bottom of the machine

      Passo 4 — Fast and medium speed outputs

      Unscrew the screws on each side of the circular discs to remove the circular plastic discs

      Passo 5 — Housing cover

      Unscrew the three Torx screws

      Passo 6 — The challenge: loosen the hidden screw

      It is not necessary to proceed to the next step if the plastic drive wheel has been removed

      Passo 7 — Special Tool

      I modified an open end wrench to drive a Tx20 bit

      Passo 8 — Open the housing

      Remove the guides (red mark). They can be reassembled after closing the housing

      Passo 9 — Planetary

      The former one has a cross fromation.

      Passo 10 — Training axis

      The former one has a cross patteren

      Passo 11 — Labels

      Cod. SER1018: Plastic bag containing the three spare parts

      Passo 12 — Fitting the gears

      Place each gear on the axis

      Passo 13 — Crank Case Assembly

      There is a lot of greasein the case. Spread the grease on the surfaces that need it.

      Passo 14 — Hidden screw

      Screw the hidden screw back in

      I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.