Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 7

Passo 7
Desolder Motors from Flight Controller
  • Use a soldering iron and solder wick to desolder the four motors from the control board.

  • If the connection holds even after removing the solder from the joint, gently pull up on the wire while applying heat to the joint until the wire separates from the PCB.

  • The motor wires are in either black-white or red-blue pairs.

  • CAUTION: Overheating the PCB can damage the traces, making it difficult or impossible to reconnect the components later on. Do not apply too much heat to the board; these traces are especially delicate due to their small size.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.